Titlebook: Sustainable Machining Strategies for Better Performance; Select Proceedings o P. Srinivasa Pai,V. Krishnaraj Conference proceedings 2022 Th

織布機(jī)

Multi-response Optimization of Machining Characteristics Using MQL Through GRA and TOPSIS Approach,l analysis, an optimum solution is obtained for the output responses, i.e. cutting temperature, surface roughness (Ra and Rz) and material removal rate. It was concluded that, vegetable oil showed better performance compared to nanofluid (Al.O.).

menopause

ATRIA

高談闊論

The Effect of Drilling Parameters on the Hole Quality of Hybrid Fiber-Reinforced Epoxy Composite,her used to compute the hole dimensions. The details of the pixel values at the entry and exit were measured digitally, and subsequently, the pixel values were used to determine the extent of damage occurred due to the drilling operation. A two-dimensional array of hole dimension with respect to the

異教徒

Evaluation of Machining Properties of Short Bamboo Fiber-Based Green Composites Using CNC Drilling analysis and ANOVA are performed for determining the influencing parameters and statistical significance of the data, respectively. The result shows that the parameters DBS and CS have contributed more effect for thrust force (TF) while input parameter CS for MRR during the machining of SBFGC. At l

Admire

意見一致

逗它小傻瓜

Experimental Investigation of Vegetable Oils-Based Minimum Quantity Lubrication Grinding by Using Iof vegetable oil and ionic liquid. Surface roughness, grinding temperature, grinding forces, grinding ratio, and specific grinding energy have been selected as output parameters. The Taguchi method that uses L9 orthogonal arrays was performed to optimize the process parameter. Results revealed that

乏味

舊式步槍

Surface Integrity of Powder Mixed Electrical Discharge Treated Substrate at High Discharge Energiesedium significantly elevates the MRR to 58.7?mm./min. However, in the conventional electrical discharge machining, the feasibility of the process for achieving the good surface integrity was constrained at high current. Moreover, the powder mixed electrical discharge machining shifts the efficiency