Titlebook: Stringer-Panel Models in Structural Concrete; Applied to D-region Johan Blaauwendraad Book 2018 The Author(s) 2018 Plates and FEM.Structur

fumble

書目名稱Stringer-Panel Models in Structural Concrete影響因子(影響力)




書目名稱Stringer-Panel Models in Structural Concrete影響因子(影響力)學科排名




書目名稱Stringer-Panel Models in Structural Concrete網(wǎng)絡公開度




書目名稱Stringer-Panel Models in Structural Concrete網(wǎng)絡公開度學科排名




書目名稱Stringer-Panel Models in Structural Concrete被引頻次




書目名稱Stringer-Panel Models in Structural Concrete被引頻次學科排名




書目名稱Stringer-Panel Models in Structural Concrete年度引用




書目名稱Stringer-Panel Models in Structural Concrete年度引用學科排名




書目名稱Stringer-Panel Models in Structural Concrete讀者反饋




書目名稱Stringer-Panel Models in Structural Concrete讀者反饋學科排名

費解

Integral Bridge,nsverse beam. A strut-and-tie model is developed from the obtained SPM solution. Finally, the translation of the two-dimensional SPM results into spatial forces and reinforcement in the transverse beam is discussed.

Amylase

2191-530X contexts of cyclical seismic activity. Finally, this book sets out how structural engineers who prefer the STM can nevertheless apply the SPM to determine a proper strut-and-tie model..978-3-319-76677-5978-3-319-76678-2Series ISSN 2191-530X Series E-ISSN 2191-5318

全能

HIKE

https://doi.org/10.1007/978-3-319-76678-2Plates and FEM; Structural Concrete; Bernoulli beam theory; Model Code 2010; Concrete plasticity

CBC471

Frame Joints and Corbels,Joints in frames and corbels are examples of D-regions. In a frame analysis, member forces are calculated in dimensionless nodes, satisfying equilibrium requirements. It is discussed how these forces have to be modified in order to act as loading on the D-region of the node under consideration. Reinforcement arrangements are presented.

實現(xiàn)

abduction

employor

Beam with a Recess, panels can be computed by hand on the basis of considerations of equilibrium alone. In the D-region, the shear stresses become substantially larger than in the adjacent beam members. Finally, the considered case is used to demonstrate the way in which the SPM result can be used to find a proper strut-and-tie model.

交響樂

Book 2018They are all familiar with B-regions, but less acquainted with the expertise required for D-regions. To design D-regions, the Strut-and-Tie Model (STM) is usually applied, a model laid down worldwide in structural codes of practice. The Stringer-Panel Model (SPM) recommended here is a companion meth