Titlebook: Recent Trends in Mechanical Engineering; Select Proceedings o Ambrish Maurya,Anmesh Kumar Srivastava,Shailesh Ma Conference proceedings 202

多嘴

Energy and Exergy Analysis of Combined Ejector Refrigeration Cycle Using Eco-Friendly Refrigerants, results of the study signify that evaporator temperature, ejector inlet pressure, condenser temperature and ejector inlet temperature strongly influence the refrigeration effect, exergetic efficiency and entrainment ratio of such system.

做方舟

Selection of Suitable Material for the Solar Panel Using SWARA and COPRAS Method,ar panel material available. The result shows that silicon metal is the most suitable material for solar panels compared to germanium and gallium phosphate. Consequently, this research could help solar panel manufacturers for proper selection of solar panel material and hence, effective utilization of renewable energy.

Mucosa

2195-4356 ng (PRIME 2021), held at the National Institute of Technology (NIT) Patna, India. The book discusses various aspects related and relevant to core areas of mechanical engineering including engineering design, production engineering, industrial engineering, automobile engineering, thermal and fluids e

暴行

Prostaglandins

Fuzzy Logic-Based PID Controller Design for Car Suspension System with Magneto-Rheological Damper,ned PID controller and only PID controller. On the basis of simulation results, it is observed that fuzzy logic-based PID controller displays more improvement in efficiency and comfort level of riders by decreasing the amplitude of the vibration as compared to PID controller.

Apoptosis

Multi-frequency Approximation for a Hysteretically Damped Tuned Mass System,nt hysteresis model developed by Biswas et al. in Int J Mech Sci 108:61–71, 2016, as the damper. We use numerical and semi-analytical approaches to study the dynamic responses of systems. The amplitude versus frequency curves?shows?two resonance peaks. The numerical and analytical results show good match.

跳脫衣舞的人

A Comprehensive Review of Cold Spray Coating Technique,rticle will adhere to the substrate due to impact and high kinetic energy. This paper presents an insight of different aspects of cold spraying process parameters related to mechanical properties and the history of the emergence of this process, and types are also reviewed.

聯(lián)想

上坡

Numerical Analysis of Supersonic Axisymmetric Inlet with Single Ramp,ratio increases with increase in Mach number, as the semi-vertex angle increases, the static pressure ratio increases. It is observed that a pressure recovery of 96% can be achieved for a free-stream Mach number of 1.5 with angle of attack of 0° for 10° cone angle and 98.5% can be achieved for 15° cone angle.

一罵死割除

Experimental Investigation of Evaporator Coil Performance with Ethylene Glycol,e on air cooling is studied. The average temperature drop in inlet air is around 9?°C for maximum cooling liquid inlet temperature as ?8?°C. The experimental results demonstrate that the ethylene glycol can be used in cooling system for small operating temperature range for different applications.