Titlebook: Materials Design and Applications III; Lucas F. M. da Silva Book 2021 The Editor(s) (if applicable) and The Author(s), under exclusive lic

Lincoln

書目名稱Materials Design and Applications III影響因子(影響力)




書目名稱Materials Design and Applications III影響因子(影響力)學科排名




書目名稱Materials Design and Applications III網絡公開度




書目名稱Materials Design and Applications III網絡公開度學科排名




書目名稱Materials Design and Applications III被引頻次




書目名稱Materials Design and Applications III被引頻次學科排名




書目名稱Materials Design and Applications III年度引用




書目名稱Materials Design and Applications III年度引用學科排名




書目名稱Materials Design and Applications III讀者反饋




書目名稱Materials Design and Applications III讀者反饋學科排名

減震

文藝

鍍金

Multiscale Modeling for Residual Stresses Analysis of a Cast Super Duplex Stainless Steelwork addresses the effect of distribution and volume fraction of phases on the magnitude and gradient of residual stresses on a cast SDSS specimen. The numerical method for the homogenization of the material properties is also addressed. The procedure followed consisted of modeling the microstructur

languor

Phono-Absorbent Behavior of New Fiberglass Plates from Mixed Plastic Material Wastesavior of the obtained plates was analyzed to define the possibility of using them for the reduction of the environmental noise. The data obtained was analyzed, and the results were compared with the characteristics of other materials which could be replaced by this new material.

expdient

說笑

GUILT

LIMN

Ambiguous

Machinability Study of Polymeric Parts Fabricated by Additive Manufacturing Under a Dry Milling Procerence purposes. With cutting speed, feed rate and cut depth as the process parameters, 13 terns were formed. Milling processes were executed on 30?x?30?x?10 mm block-shaped 3D prints and surface roughness values were obtained via a portable roughness tester. It was found that the most influential p