Titlebook: Machining, Joining and Modifications of Advanced Materials; Andreas ?chsner,Holm Altenbach Book 2016 Springer Science+Business Media Singa

新字

Forming Temperature Investigation of Aluminum and Aluminum/Silicon Carbide Using Image Texture Feats. In the present work, the effect of forming temperature on the forming behavior of aluminum and aluminum reinforced by 10?wt% SiC was studied by using image texture features after using the compression test which was done at an elevated temperature range of 300–550?°C and a constant strain rate of

招致

指數(shù)

,The Influence of Two Different Casting Moulds on the Fatigue Properties of the Al–Si–Cu Cast Alloy, parameters (especially eutectic Si particles and Fe-rich intermetallic phases) has considerable influence on fatigue properties in both types of experimental materials. The results show that the fatigue lifetime is longer for samples casted into a metallic mould (chill casting) (average fatigue lif

GROUP

omnibus

緯線

The Material Hardness and Tensile Strength of AA5083 Aluminum Alloy Friction Stir Welding Lap Jointes after attaining marginal speed. Deflections of friction stir welded specimens and base materials were compared and they exhibited almost similar trends at different spots in the welding nugget, heat affect zone and thermal material affected zone of all the specimens [.–.].

cloture

Mechanism of Creating the Topography of an Abrasive Water Jet Cut Surface,a which has not received much attention. In material disintegration, the mechanisms of cutting, plastic deformation, fatigue and fracture participate physically. By studying the surface topography we can better understand the process of abrasive water jet machining, specify the theory and correctly

忘川河

lacrimal-gland

Laser Beam Machining, Laser Beam Hybrid Machining, and Micro-channels Applications and Fabrication mainly classified into seven categories named as: (1) Introduction, (2) Laser Beam Machining (LBM), (3) Laser Assisted Machining (LAM), (4) Laser Chemical Machining/Etching (LCM/E), (5) Laser Assisted Electrochemical Machining (LAECM) and (6) Under-Water Laser Ablation (UWLA) and (7) Micro-channel

極少

Book 2016ny cases, forming and machining technologies require additional post-treatment to achieve the required level of surface quality or to furnish a protective layer. Accordingly, sections on laser treatment, shot peening and the production of protective layers round out the book’s coverage..