Titlebook: Limits, Modeling and Design of High-Speed Permanent Magnet Machines; Aleksandar Borisavljevic Book 2013 Springer-Verlag Berlin Heidelberg

languid

Aleksandar Borisavljevic?2), ist die gewachsene Offenheit gegenüber Formen der Konstruktion von Wirklichkeit insbesondere in der englischsprachigen Policy-Analyse mit einer Etablierung des Diskursbegriffes einhergegangen. Diese Form der Policy-Analyse beginnt mit dem Befund, dass unterschiedliche Diskurse, Definitionen und

泄露

ar when an alkyl chain is the substituent. They include a vibration near 1070 cm., which is given the general assignment δ′(chain)?. The question mark indicates that it is an unknown group frequency. If a methyl group is present, a band near 1150 cm. is found, and this is assigned as δ′(CH.)?. If tw

收到

MIME

無(wú)能性

Bearings for High-Speed Machines,achining spindles [1]. Demands for increasing tangential speeds and, often, positioning accuracy could not be achieved by using standard journal or ball bearings. Therefore, the requirement for speed of the machinery brought about improvements in bearing technology. Enhancements have been either sou

地殼

Design of the High-Speed-Spindle Motor,pment of a built-in electrical spindle drive which would facilitate high rotational speed of the spindle and accurate micro-milling. This chapter will present the design of the spindle motor, from a conceptual design to electromagnetic and structural optimization of the motor.

表主動(dòng)

troponins

Experimental Results,geometries and the fast rotation itself. To test many of the phenomena discussed in this thesis, dedicated test setups would be necessary although that would exceed the scope of the project. The setup that was developed for the purpose of the thesis project was primarily designed to demonstrate the

偽證

Cabg318

Aleksandar Borisavljevice, Diskurs, Argumentation und Rhetorik in den Mittelpunkt gerückt. Besonderes Interesse genie?t dabei die Frage, wie unterhalb einer scheinbar neutralen, apolitischen Oberfl?che normative Vorannahmen operieren (Fischer 2003, S. 14). Das folgende Kapitel.Das Kapitel beginnt bei übergeordneten Konzept