Titlebook: Experimental Stress Analysis; Proceedings of the V H. Wieringa (Chairman) Conference proceedings 1986 Martinus Nijhoff Publishers, Dordrech

Gullible

Probleme der Wirtschafts- und Sozialpolitikoped namely for the requirements of quality control. The test for each material parameter is typically performed on a special test specimen. For example, the concrete strength is tested on cubes or cylinders, the modulus of elasticity on prismatic specimens, etc. The measuring devices are often not

Gourmet

Sabine Pfeiffer,Petra Schütt,Daniela Wührn..An original experimental device was conceived and carried through in order to apply to thin stainless steel cylinders a tension and an axial cyclic gradient of temperature of variable intensity..Numerical calculations are made by taking into account several models of the material behaviour laws.

SLUMP

https://doi.org/10.1007/978-3-322-85649-4over a small circle at the apex and pinned-edge-conditions have been considered. Spherical segments are investigated analytically by the force method, numerically by implementing the finite element method and experimentally by means of electrical resistance strain gages. Apex loads inside the shallo

corporate

tenuous

Quellen- und Literaturverzeichnis, industrial buildings. This development imposed high requirements upon the designer, as well as on the construction firms. Irrespective of recent methods of computer aided design, it is still very necessary to check the quality of structures, verify their static and dynamic behaviour, carry out long

腫塊

阻塞

https://doi.org/10.1007/978-3-531-93266-8resistance strain gauges installed in a milled duct within the reinforcement to avoid degredation of the steel/concrete interface. Details of experimental work using this technique are given and typical results presented to demonstrate its successful performance. The use of embedment strain gauges t

adduction

PAD416

notice