Titlebook: Enabling Industry 4.0 through Advances in Manufacturing and Materials; Selected Articles fr Amiril Sahab Abdul Sani,Muhammed Nafis Osman Za

過渡時(shí)期

Amiril Sahab Abdul Sani,Muhammed Nafis Osman ZahidPresents selected articles from the Manufacturing and Materials track of the iM3F 2021 conference, Malaysia.Highlights recent findings in manufacturing and materials pertinent toward Industry 4.0.Is u

Acupressure

arthroplasty

Oleg V. Shishkin,Svitlana V. Shishkinamanufacturing industry for achieving low cutting force. This is due to nickel-based superalloys is difficult-to-machine materials, thus increase in spindle speed will lead to thermal softening that may reduce cutting force, while decrease in feed per tooth will decrease the amount to shear unwanted

CLAP

表兩個(gè)

注意

過份艷麗

Jerzy Leszczynski,Manoj K. Shuklald be subjectively or objectively. Many studies emphasized the effectiveness of using objective techniques to derive criteria weights, like using entropy as a measure of fuzziness of the fuzzy sets to detect criteria weights. Despite that, still this subject under study and debate between researcher

GROWL

https://doi.org/10.1007/978-3-642-05067-1udies the performance of assessment model for injection moulding parameters using Taguchi and ANOVA method. The objective of this research is to identify the best injection moulding parameters in producing plastic pallets in term of compressive strength when subjected to a constant load. Melting tem

Aprope

燒瓶

PIC Interfaced to I2C Compatible Devices,is one of AM technologies that rapidly growing due to its ability to fabricate complex geometric parts with lower cost. However, this technique requires further improvement and further investigation due to the shortcomings such as poor surface finish and low mechanical strength. This work is to dete