Titlebook: Diagnosis and Fault-Tolerant Control; Mogens Blanke,Michel Kinnaert,Marcel Staroswiecki Book 20031st edition Springer-Verlag Berlin Heidel

寓言

書目名稱Diagnosis and Fault-Tolerant Control影響因子(影響力)




書目名稱Diagnosis and Fault-Tolerant Control影響因子(影響力)學科排名




書目名稱Diagnosis and Fault-Tolerant Control網絡公開度




書目名稱Diagnosis and Fault-Tolerant Control網絡公開度學科排名




書目名稱Diagnosis and Fault-Tolerant Control被引頻次




書目名稱Diagnosis and Fault-Tolerant Control被引頻次學科排名




書目名稱Diagnosis and Fault-Tolerant Control年度引用




書目名稱Diagnosis and Fault-Tolerant Control年度引用學科排名




書目名稱Diagnosis and Fault-Tolerant Control讀者反饋




書目名稱Diagnosis and Fault-Tolerant Control讀者反饋學科排名

Extricate

排斥

Fault-tolerant control of continuous-variable systems,es an overview of the available methods for dealing with faults in sensors, actuators and within the controlled system. The earlier results on diagnosis are employed to automatically re-design the control law. Small faults can be tackled by fault accommodation, where the controller parameters are ad

新字

Diagnosis and reconfigurable control of discrete-event systems,ution to the state observation problem developed in Section 8.3, the fault diagnostic problem will be solved in Section 8.4 by “observing” the unknown state of the fault model. Section 8.5 shows how a supervisor can be reconfigured after a fault has been detected.

condemn

相信

相信

Book 20031st editionthe system. Erroneous sensor readings are the reason for operating points that are far from the optimal ones. Wear reduces the efficiency and quality of a production line. In most fault situations, the system operation has to be stopped to avoid damage to machinery and humans. As a consequence, the

hieroglyphic

Analysis based on components and architecture,s are discussed and their aggregation into generic components at a higher level is illustrated. Formal methods for describing generic components are introduced. Algebraic and graph-theoretic methods are employed to analyse the propagation of faults through the faulty system.

AGOG

潰爛

Fault diagnosis of continuous-variable systems,lution of these problems leads to a diagnostic system which is separated in two parts: a residual generation module and a residual evaluation module. Particular attention is paid to the link between these two parts when using stochastic models.