Titlebook: Designing Transistor I.F. Amplifiers; W. Th. H. Hetterscheid Book 1966 Springer-Verlag Berlin Heidelberg 1966 applied physics.design.physi

Annihilate

書目名稱Designing Transistor I.F. Amplifiers影響因子(影響力)




書目名稱Designing Transistor I.F. Amplifiers影響因子(影響力)學科排名




書目名稱Designing Transistor I.F. Amplifiers網絡公開度




書目名稱Designing Transistor I.F. Amplifiers網絡公開度學科排名




書目名稱Designing Transistor I.F. Amplifiers被引頻次




書目名稱Designing Transistor I.F. Amplifiers被引頻次學科排名




書目名稱Designing Transistor I.F. Amplifiers年度引用




書目名稱Designing Transistor I.F. Amplifiers年度引用學科排名




書目名稱Designing Transistor I.F. Amplifiers讀者反饋




書目名稱Designing Transistor I.F. Amplifiers讀者反饋學科排名

Arthr-

凝乳

凝乳

常到

Automatic Gain Control of Transistor I.F. Amplifiers, or nearly constant for a wide range of input signal strength variations at the aerial terminals of the receiver, see Fig. 7.1. This can be achieved by employing a system that automatically provides the desired reduction of gain of the R.F. and I.F. sections of such receivers when the input signal s

superfluous

Practical Design Method for I.F. Amplifiers,ts will be reviewed in the light of a practical design procedure. Also limitations which might be imposed on the design due to the construction of the bandpass filters are considered. These considerations lead to a step-by-step design procedure to be presented in Chapter 14.

superfluous

人類

Design Examples of Incorporating Spreads the Choice of an AGC-System for an I.F. Amplifier of a Tellistic figure for the total effect on performance of these deviations from nominal conditions. In this chapter overall spreads in the performance of a complete high-frequency system of a television receiver, including AGC, will be calculated. The various calculations will elucidate the different asp

cataract

radiograph

Design Charts,f the regeneration coefficient ., and also graphs in which the value of the reduced determinant . and the losses .. are plotted against .. The design charts are given for three different amplifier configurations, termed “I”, “II” and “III” respectively, see Fig. 15.1.