Titlebook: Current Problems and Ways of Industry Development: Equipment and Technologies; Olga G. Shakirova,Oleg V. Bashkov,Akhmet A. Khusai Conferen

空格

書目名稱Current Problems and Ways of Industry Development: Equipment and Technologies影響因子(影響力)




書目名稱Current Problems and Ways of Industry Development: Equipment and Technologies影響因子(影響力)學科排名




書目名稱Current Problems and Ways of Industry Development: Equipment and Technologies網絡公開度




書目名稱Current Problems and Ways of Industry Development: Equipment and Technologies網絡公開度學科排名




書目名稱Current Problems and Ways of Industry Development: Equipment and Technologies被引頻次




書目名稱Current Problems and Ways of Industry Development: Equipment and Technologies被引頻次學科排名




書目名稱Current Problems and Ways of Industry Development: Equipment and Technologies年度引用




書目名稱Current Problems and Ways of Industry Development: Equipment and Technologies年度引用學科排名




書目名稱Current Problems and Ways of Industry Development: Equipment and Technologies讀者反饋




書目名稱Current Problems and Ways of Industry Development: Equipment and Technologies讀者反饋學科排名

著名

Banister

典型

種子

Numerical Calculation of the Heat Sink Parameters of the Shell Turbine Vanes at the Modeling of thedence plotting of cooling parameters on the coating layers number for a given long-term strength of the shell material..: The research methodology is based on the application of the Fourier differential equation of thermal conductivity, boundary conditions of heat transfer, and the use of the develo

出處

出處

Removing Weld Defect Causes in Aviation Stainless Steel Piping Elements,ct of welding conditions was studied for the ranges of welding amperage and shielding gas (argon) consumption, and electrode grind angle recommended by the operating procedure (PI 1.4.75 - 2000). The quality of the completed welds was determined and evaluated by visual and radiographic inspection. F

acquisition

樸素

Experimental Validation of Identification Crack Propagation in Plates as a Source of Acoustic Emissnals in metallic plate..: For research in this work, aluminum alloy 1163 was used as a sample. An initial crack was grown in the sample by means of cyclic bending. After that, the sample was loaded with a single bend with a fixed deformation using a cantilever loading device. Damage in the form of e

敬禮

Investigation of the Influence of Electrical Modes on the Morphology and Properties of Oxide CoatinThe studies were carried out on samples of 1163 alloy clad with aluminum. In the study, the following parameters of microarc oxidation were changed: the rate of slow voltage growth, the period of slow voltage growth. After applying the oxide coating, the surface morphology and hardness of the coatin