Titlebook: Contactless System for Measurement and Evaluation of Machined Surfaces; Juraj Ru?barsky Book 2022 The Author(s), under exclusive license t

Aerate

Measurement of Roughness Parameters by Contact Surface Roughness Tester,Measurement of experimental samples produced by the AWJ technology was carried out using the contact method due to verification of the declared roughness of the produced samples and due to comparison of the values measured by contactless laser profilometer LPM with the values measured by contact roughness tester Mitutoyo SJ 400.

regale

Measurement of Roughness Parameters by Contactless Laser Profilometer LPM,Using a contactless laser profilometer the surface of samples was measured in 190 steps with the step length of 0.11?μm on ten levels of the stepping interval with the step slide of 2?mm into the depth of surface material. The Gain mode (amplification of signal image in the camera) amounted to 1.

JOG

欺騙手段

Conclusion,The publication deals with the research and development of a contactless system for measurement and evaluation of the selected feature of the machined surfaces. According to the existing structural solutions we designed and constructed the contactless laser profilometer intended for measurements and evaluation of surface roughness.

hair-bulb

Onerous

無價值

mortgage

Production of Experimental Samples,. The samples are made of three material types—aluminum with standardized marking EN5083, stainless steel with standardized marking A304 (stainless steel), and constructional steel with standardized marking S235JR. These materials were selected for being the most frequently used and available materi

凹槽

Contactless System for Measurement and Evaluation of Machined Surfaces

繁忙