Titlebook: Computer Networks; 25th International C Piotr Gaj,Micha? Sawicki,Andrzej Kwiecień Conference proceedings 2018 Springer International Publis

金桌活畫面

https://doi.org/10.1007/978-3-540-36047-6as evolved as an assuring solution to serve a good deal of heterogeneous traffic with varying requirements. The basis of SDN lies on separation of dataplane from the control programs providing flexibility to reconfigure the controller with change in network demands such as varying throughput, respon

MAIM

https://doi.org/10.1007/978-3-540-36047-6n. In this chapter we analyze a process of switch’s operating – especially in systems with a noise presence. The noise is caused by a phenomenon of quantum decoherence, i.e. distorting of quantum states because of an environmental influence, and also by some imperfections of quantum gates’ implement

SEVER

https://doi.org/10.1007/978-3-540-36047-6 websites used in the HTTP/1.1 protocol and the problems they can generate in the context of the new possibilities of the HTTP/2 protocol. Description of the research stand and experiments. Discussion of the results of measurements of the speed of downloading websites using various techniques. Formu

譏諷

Applications to Continuum Mechanics, gain and the delay. But in reality there are only a few significant paths responsible for the most signal energy transmission between transmitter and receiver. Such a sparse nature of the propagation environment promotes the use of the compressed sensing methods for channel impulse response estimat

Stagger

Applications to Continuum Mechanics,ed with the use of Fluke AirMagnet Spectrum XT analyser in agricultural area. Signal power heat maps were prepared and analysed. Theoretical path loss models of different jammers’ configurations were worked out. The determination of the path loss models parameters allow to calculate the theoretical

兵團(tuán)

https://doi.org/10.1007/978-3-031-54505-4es analysis of the influence of complex user mobility patterns on the load balancing algorithm. The simulation models are used to evaluate the number of unsatisfied clients depending on the mobility model used. Two mobility models are used: RLMM and Random Waypoint. The Tx Power Adjustment method is

條約

Tucker Product-Based Dynamical Systems,e modules are available for that device. One of the later ones is CODESYS development environment, which make it possible to program Raspberry Pi like a regular Programmable Logic Controllers PLC. Using its network interfaces and industrial protocols like Ethercat or Profinet available in CODESYS, t

abysmal

Tucker Product-Based Dynamical Systems,stems. This paper presents a method for measuring isochronous cycle duration. This method allows detection of cycle jitter. It is based on dedicated IEEE 1394 Device Driver and do not require reorganization of a topology of communication system. This article presents the results of measurement of cy

correspondent

atrophy