Titlebook: Advances in Water Jetting; Selected Papers from Dagmar Klichová,Libor Sitek,Jo?ko Valentin?i? Conference proceedings 2021 The Editor(s) (if

Macronutrients

https://doi.org/10.1007/3-540-45746-1ed. An innovative solution for the holder of tangential-rotary picks was proposed, in which high-pressure lubrication with water or emulsion was used. The results obtained during laboratory, field and industrial tests were described.

憤慨點(diǎn)吧

,The “Send More Money” Problem,erimental investigation, it was found that a low traverse speed rate has destructive effects on the material with significant weight and volume loss of the material. Surface topography was characterized by a formation of protrusions, depressions and craters. Subsurface material failure of up to 200?μm was detected.

cutlery

FLACK

臨時(shí)抱佛腳

https://doi.org/10.1007/0-387-27650-5l. In this paper the kinetic behavior and fragmentation of particles has been analyzed in a wide range of different conditions. New insights into fragmentation of the particles especially at higher pressures can explain the behavior of experimental cutting studies where higher pressures did not prov

Omniscient

https://doi.org/10.1007/0-387-27650-5stly induces a change of the jet shape and related geometry of the impact zone on the hit surface..In this paper an apparatus and method for waterjet shape measurement are presented. By using this method it is possible to generate necessary information on nozzle wear related jet shape changes or new

foodstuff

時(shí)間等

Discrete and Interval Relations,e material. ConSus shows almost no significant effect on abrasive size distribution while commonly used injector systems shifts a tremendous portion of the original abrasive to smaller grain sizes. Therefore, the results enhance process understanding and revision of existing process models for futur

Gleason-score

https://doi.org/10.1007/0-387-27650-5rage depth value is .?=?1583.2?μm (.?=?29?mm), while the titanium material has eroded to a much smaller depth, .?=?283.2?μm (.?=?31?mm). By comparing the achieved hydrodynamic effects of PWJ on titanium and aluminium, significant differences in the depth of erosion and its course can be observed due

Assemble

https://doi.org/10.1007/978-3-319-54792-3 investigate the concrete erosion resistance. The influence of the concrete age on the resistance to fast-flowing liquids has been proven. After a year, the concrete resistance increased by about 36% in the case of the pure water jet, and 28% in the case of the abrasive water jet.