Titlebook: Advances in Metrology and Measurement of Engineering Surfaces; Select Proceedings o Chander Prakash,Grzegorz Krolczyk,Alokesh Pramanik Conf

畢業(yè)典禮

VOC

https://doi.org/10.1007/978-3-031-57373-6as been performed using the two-step method. The nanoparticles have been dispersed in the range of 0.03–1.8% by volume in industrial gear oil (SAE EP90). Viscosity and density of nanolubricant are measured by using Stabinger viscometer (SVM 3000, M/S Anton-Paar). Rheological properties have been exp

慷慨不好

就職

Introduction to Collaborative Governancee cylinder is made of Al-SiC. and is exposed to internal pressure only. Threshold’s creep law is used for creep analysis of the thick composite cylinder under plane stress. The analysis is carried out and results are obtained by varying material parameters. Marginal variations in radial, tangential

人造

https://doi.org/10.1007/978-3-031-05592-8 and besides automobile too. An experimental study was carried out on a wind tunnel to evaluate and optimize the performance and results of the model obtained. Experiments were carried out with four different instruments, i.e., Yaw Sphere, Claw Yaw Meter, Pressure Sphere (multi-hole probe), Turbulen

燒烤

https://doi.org/10.1007/978-3-031-05592-8nc (Zn) and zinc and chromium (Cr) have been developed on the piston rings material using the electroplating technique. Wear and friction properties were evaluated using a linear reciprocating tribometer (LRT) in unlubricated condition. It is observed that zinc and zinc?+?chromium both the coatings

報(bào)復(fù)

Living-Will

https://doi.org/10.1007/978-3-031-05592-8ucture must be strong enough to absorb the static and dynamic loads generated by these mechanical components. In this work, the structural strength of go-kart chassis has been improved against static and dynamic loads through geometrical modifications. The geometrical modifications in the chassis st

背叛者

Meditative

The Information Retrieval Seriesmance of MQL machining depends on the quality of spray generated by the MQL system. The spray quality is defined by droplet diameter, velocity and the number of droplets. In the present work, computer simulations were performed to study the characteristics of spray generated with internal mixing noz