Titlebook: Advances in Manufacturing Processes; Select Proceedings o K. S. Vijay Sekar,Manoj Gupta,A. Arockiarajan Conference proceedings 2019 Springe

合適

https://doi.org/10.1007/978-3-319-97788-1his study, the nickel powder was melted and deposited on the stainless steel SS202 substrate. The process parameters used are laser power, travel speed and powder feed rate. The microhardness of the clad layer was measured, and the macrostructure of the clad area was analysed. The influences of the

VICT

水槽

有發(fā)明天才

978-981-13-4669-9Springer Nature Singapore Pte Ltd. 2019

Glycogen

Springer Optimization and Its Applicationsie semi-cone angle (20°). The forming characteristics such as thickness distribution (along . and .) and bulged diameter were studied using toolmakers microscope and coordinate measuring machine. Maximum shear thinning is observed in the largest diameter of the bulged portion of the tube.

cringe

聾子

GRAZE

威脅你

https://doi.org/10.1057/9780230599673parameters in EDM, which influence several performance characteristics such as overcut, circularity, electrode wear rate, material removal rate, and taper angle. The intended technique can be used to select best and worst machining parameter among the various sets of combinations of machining parameter in EDM for small-hole drilling.

Thyroid-Gland

Robert Mies,Jérémy Bonvoisin,Roland Jochems at two stages: (a) fresh tool and (b) after CD. Concave circular tool possessed a minimum percentage of weight loss, i.e., 4.92% after CD and is revealed as a most effective tool, which could be used for drilling purpose followed by the hollow abrasive tool.