Titlebook: Advances in Manufacturing III; Volume 4 - Measureme Magdalena Diering,Micha? Wieczorowski,Alejandro Pe Conference proceedings 2022 The Edit

Inordinate

Axillary

L Gebauer,M S?llner,J.M Leimeisterlayers is the use of Wire Arc Additive Manufacturing process, where 3D metallic structures are created using welding technologies, i.e. Gas Metal Arc Welding. In the paper an analysis of measurement devices for surfaces after that kind of manufacturing was presented. A computer tomograph as well as

Ambulatory

Relevante Rechtsfragen des Cloud-Computingsible to observe the internal structure of virtually any object and the only limitation is the ability to overexpose it. Tomography is a technique that allows imaging on the basis of sections or cross-sections obtained by means of a wave penetrating the object. The devices used in X-ray computed tom

明智的人

Roland Frank,Gregor Schumacher,Andreas Tammal. In particular, the influence of the moisture of the material on the result of the process has not yet been sufficiently described. The article presents a test that allows to determine this effect in an experiment requiring a relatively small number of repetitions. As a case study, a test for ide

PALMY