Titlebook: A Background to Engineering Design; Peter Polak Textbook 1976Latest edition Peter Polak 1976 design.engine.engineering design

里程表

書目名稱A Background to Engineering Design影響因子(影響力)




書目名稱A Background to Engineering Design影響因子(影響力)學科排名




書目名稱A Background to Engineering Design網絡公開度




書目名稱A Background to Engineering Design網絡公開度學科排名




書目名稱A Background to Engineering Design被引頻次




書目名稱A Background to Engineering Design被引頻次學科排名




書目名稱A Background to Engineering Design年度引用




書目名稱A Background to Engineering Design年度引用學科排名




書目名稱A Background to Engineering Design讀者反饋




書目名稱A Background to Engineering Design讀者反饋學科排名

GENUS

騙子

larder

Ke Xu,Haitao Liu,Xingqiao Zhu,Yongbin Songe observations relevant to a current need. Examples of each are the transistor, the electric light bulb, the Bessemer converter and the Mannesmann tube-piercing method. In the case of the electric light bulb the design concept came first, derived from logical use of scientific principles, followed b

柔軟

Matteo Russo,Elie Gautreau,Med Amine Laribia problem tend towards safety and which towards danger of failure. The trouble starts when attempting to give it a numerical value. In design practice there is no single value for assessing safety margins, as can be seen from the examples below.

畢業典禮

Mingyang Wang,Shuwen Li,Yuehai Sunride it. How is intrinsic stability obtained? There is a popular notion that the head angle confers stability, yet early bicycles had upright steering heads. A little thought shows that sloping heads actually tend to de-stabilise. Under gravity the load and earth try to come together. Relative to th

文件夾

連詞

Taiki Suwa,Daisuke Matsuura,Tsune Kobayashise; to call for materials new to the maker can produce problems of supply, identification, treatment and storage. So whenever possible the designer should check up on this point and possibly change one or the other, material or maker.

羽飾

https://doi.org/10.1007/978-3-031-45709-8e usually with an electric arc. The workpiece usually forms one of the electrodes; the other is guided by the welder and is either of tungsten, which is not intended to melt, or of filler material which forms part of the joint. Other methods use local heating within the joint region, sometimes combi

允許