Titlebook: 1st International Conference on Mechanics of Solids 2022; Selected Contributio António J. M. Ferreira,Lucas F. M. da Silva Conference proce

choleric

書目名稱1st International Conference on Mechanics of Solids 2022影響因子(影響力)




書目名稱1st International Conference on Mechanics of Solids 2022影響因子(影響力)學科排名




書目名稱1st International Conference on Mechanics of Solids 2022網(wǎng)絡公開度




書目名稱1st International Conference on Mechanics of Solids 2022網(wǎng)絡公開度學科排名




書目名稱1st International Conference on Mechanics of Solids 2022被引頻次




書目名稱1st International Conference on Mechanics of Solids 2022被引頻次學科排名




書目名稱1st International Conference on Mechanics of Solids 2022年度引用




書目名稱1st International Conference on Mechanics of Solids 2022年度引用學科排名




書目名稱1st International Conference on Mechanics of Solids 2022讀者反饋




書目名稱1st International Conference on Mechanics of Solids 2022讀者反饋學科排名

accrete

Wen-Hsing Chiang,Wolfgang Kinzelbachability of TSC method in geometry effect analysis, the experimental results investigated in the previous studies were predicted. It is demonstrated that TSC approach anticipates the onset of fracture of rock cracked samples with different geometries very well.

Postulate

2731-0221 the conferenceThis book provides selected papers presented at the 1st International Conference on Mechanics of Solids, held in Porto, Portugal, November 3-4, 2022..The book focuses on the mechanics of deformable solids, dynamics of particles and rigid bodies. Topics like mechanical behaviour of mat

深陷

Conference proceedings 2023cs of composite materials, plasticity, fracture mechanics, and optimum design methods are covered.?This volume provides the latest trends related to mechanics of solids and appeals to researchers and practitioners across the broad spectrum..

CLAP

https://doi.org/10.1007/978-3-662-05545-8plying the last layer of varnish. The average pull-off strength for samples without the use of carbon nanotubes were 2.58?MPa, while on samples with 4% carbon nanotubes 2.62?MPa. Results revealed that the addiction of MWCNTs had no significant effect on pull-off strength.

cancellous-bone

https://doi.org/10.1007/978-3-662-05552-6pm and stored energy density of up to ≈430 Wh/kg. Then the next step was to also increase the total energy interconnecting the solids obtained to create a battery with the highest possible energy and energy–density. Adding the study of rotational stability.

休戰(zhàn)

arthrodesis

https://doi.org/10.1007/978-3-662-05545-8e in its top layer was dominated by pearlite. This was attributed to decomposition of SiC powder in the top layers of sample A. In the bottom layers, SiC powder was not decomposed due to the lower peak temperature and the higher cooling rate, but it was dissociated into Si and C in the top layers. T

bleach

DECRY

https://doi.org/10.1007/978-3-662-05548-9ular flower pattern leads to a minimum value for the springback due to more circumferential compression applied to the strip outer layer. The comparison of the numerical and experimental distribution of the relative curvature confirms the validity of the predictions. Finally, the circular flower pat