標題: Titlebook: Structural Integrity and Fatigue Failure Analysis; Experimental, Theore Grzegorz Lesiuk,Mieczyslaw Szata,José A.F.O. Corre Conference proce [打印本頁] 作者: 手或腳 時間: 2025-3-21 18:30
書目名稱Structural Integrity and Fatigue Failure Analysis影響因子(影響力)
書目名稱Structural Integrity and Fatigue Failure Analysis影響因子(影響力)學科排名
書目名稱Structural Integrity and Fatigue Failure Analysis網(wǎng)絡公開度
書目名稱Structural Integrity and Fatigue Failure Analysis網(wǎng)絡公開度學科排名
書目名稱Structural Integrity and Fatigue Failure Analysis被引頻次
書目名稱Structural Integrity and Fatigue Failure Analysis被引頻次學科排名
書目名稱Structural Integrity and Fatigue Failure Analysis年度引用
書目名稱Structural Integrity and Fatigue Failure Analysis年度引用學科排名
書目名稱Structural Integrity and Fatigue Failure Analysis讀者反饋
書目名稱Structural Integrity and Fatigue Failure Analysis讀者反饋學科排名
作者: Classify 時間: 2025-3-21 20:17
Three-Dimensional Fractography for Conventional and Additive Manufactured Steels After Bending-Torsiolid round bars with lateral notches made of conventional steel and hollow round bars with transversal holes for AM specimens. The investigations indicate that arithmetical mean height, Sa, decreased and fractal dimension, Df, increased with higher ./. ratios and higher fatigue lives.作者: antidepressant 時間: 2025-3-22 03:24 作者: Vulnerary 時間: 2025-3-22 07:07
Microstructural and Mechanical Characterization of Riveted 19th-century Steels in Terms of Fatigue LL software. Obtained results suggest significant fatigue lifetime decrease caused by degradation processes. Also, crucial role plays fracture resistance and thus, higher fracture toughness properties expressed in cyclic stress intensity factor . obtained for steel in post-operated state.作者: Facilities 時間: 2025-3-22 11:29
Acoustic Emission Characteristics for Determining Fatigue Damage Behaviouration between acoustic emission characteristics and the normalised cycles for all sensors. Hence, the response on the acoustic emission characteristic can be used to predict fatigue damage prognosis of the reinforced concrete beam.作者: Ambulatory 時間: 2025-3-22 16:26 作者: Medicaid 時間: 2025-3-22 17:55 作者: 笨拙的我 時間: 2025-3-22 22:39
Multiaxial Fatigue Behaviour of SLM 18Ni300 Steel principal stress at the hole. Fatigue crack initiation life was estimated based on the SWT parameter, defined from uniaxial low-cycle fatigue tests performed for smooth standard specimens under fully reversed strain-controlled conditions. Overall, predicted lives are in agreement with the experiments.作者: cavity 時間: 2025-3-23 02:33 作者: AUGUR 時間: 2025-3-23 06:10
Accelerated Fatigue Test Procedure for Leaf Springs Applied to Semi-Trailersthat can significantly vary depending on the manufacturer, thus, imposing a barrier to seek for more efficient and safe structures. Hence, the main objective of the present work is to create, starting from experimental evidences, a solid technical basis for the creation of a valid accelerated fatigu作者: FIN 時間: 2025-3-23 11:32
Early Evidences on the Rotating Bending Fatigue Properties of Ductile and Vermicular Cast Ironslent mechanical and tribological properties, but also to a certain flexibility of the same. In fact, it can be produced in various types of metal alloy, which differ significantly in properties: from the poorly performing, but economical white cast iron, to the excellent resistant nodular cast iron.作者: 斷斷續(xù)續(xù) 時間: 2025-3-23 16:32 作者: 偽書 時間: 2025-3-23 19:21 作者: 愚蠢人 時間: 2025-3-24 02:03
Acoustic Emission Characteristics for Determining Fatigue Damage Behaviourgate the acoustic emission characteristics of the reinforced concrete beam subjected to fatigue loading at different sensors. Laboratory experiments were performed on the 150?mm?×?150?mm?×?750?mm reinforced concrete beam under fatigue loading in conjunction with acoustic emission monitoring. Then, t作者: 獸皮 時間: 2025-3-24 04:32 作者: 來就得意 時間: 2025-3-24 08:32
Predicted Distribution in Measured Fatigue Life from Expected Distribution in Cyclic Stress–strain Panalysis a challenge. Using a strain energy based damage model to predict strain-life and stress-life curves from individual specimens (Huffman in Int J Fatigue 88:197–204, 2016 [1]), a set of curves can be created to more accurately reflect the range of strain-life values that would come from more 作者: 大炮 時間: 2025-3-24 11:15
Modification Optimization-Based Fatigue Life Analysis and Improvement of EMU Gearmulative damage theory. A fatigue life analysis method by modifying S–N curve and considering material difference is presented to improve the fatigue life of EMU gear based on shape modification optimization. A corrected method for stress amplitude, average stress, and S–N curve is proposed, which c作者: 共棲 時間: 2025-3-24 15:02
Fatigue Life Analysis of Strain Loadings Using Effective Strain Damage Approach with the Consideratiffect. Fatigue failure of automobile coil spring is common occurrence that is subjected to random loading due to road conditions. Load sequence effect was found to have more significant effects in the automobile coil spring strain signals with many high amplitude events. Strain time histories of coi作者: 誘導 時間: 2025-3-24 19:48 作者: Aerate 時間: 2025-3-25 00:01
FE Modelling of the Fatigue Behaviour of L-PBF Inconel 718 with As-Built Surfacesas been demonstrated that surface roughness has a key influence on high-cycle fatigue properties of components. As-built surfaces contain notch-like features that work as stress concentration sites where fatigue crack nucleation may occur. These typical morphologies due to Laser-Powder Bed Fusion (L作者: 綠州 時間: 2025-3-25 05:30
Three-Dimensional Fractography for Conventional and Additive Manufactured Steels After Bending-Torsical aspects of fracture for notched specimens made of high-strength steels processed by both conventional and additively manufacturing (AM) techniques, an optical surface profilometer was used. Three bending moment to torsion moment ratios (./.) were studied, i.e. 2, 1 and 2/3. The geometries were s作者: iodides 時間: 2025-3-25 07:40 作者: SPER 時間: 2025-3-25 13:47
Metal Additive Manufacturing of End-Use Components and Parts: A Practical Overviewnd parts by additive manufacturing (AM). The latest achievements and news are also discussed with special attention on defining the real production capability of each technological AM option under investigation. As general conclusion, by the present technical review, it was possible to confirm the p作者: senile-dementia 時間: 2025-3-25 18:05 作者: negotiable 時間: 2025-3-25 22:30 作者: aggressor 時間: 2025-3-26 03:05 作者: synovium 時間: 2025-3-26 04:26 作者: AGATE 時間: 2025-3-26 10:33
Early Evidences on the Rotating Bending Fatigue Properties of Ductile and Vermicular Cast Ironse moment in terms of utilization, despite different potentials. This experiment compares the results of the Rotating Bending Fatigue test for cast iron specimens made under foundry process conditions as identical as possible in the way to reduce bias.作者: Bother 時間: 2025-3-26 15:19
Rotating Bending Fatigue of Spheroidal Cast Ironse moment in terms of utilization, despite different potentials. This experiment compares the results of the Rotating Bending Fatigue test for cast iron specimens made under foundry process conditions as identical as possible in the way to reduce bias.作者: Basal-Ganglia 時間: 2025-3-26 18:23
Finite Element Analysis of Distortions, Residual Stresses and Residual Strains in Laser Powder Bed Fng problem. Simulations are proposed and conduced that aim at comparing two software packages against each other and against experimental data; results are discussed, and lastly, conclusions are achieved.作者: 耐寒 時間: 2025-3-26 21:12 作者: venous-leak 時間: 2025-3-27 04:50 作者: 進步 時間: 2025-3-27 07:58
Grzegorz Lesiuk,Mieczyslaw Szata,José A.F.O. CorreExplains the structural integrity of materials and components.Provides fatigue failure analysis based on experimental and numerical investigations.Explores fatigue life predictions based on global and作者: intercede 時間: 2025-3-27 13:10
978-3-030-91849-1The Editor(s) (if applicable) and The Author(s), under exclusive license to Springer Nature Switzerl作者: MANIA 時間: 2025-3-27 16:49
Structural Integrity and Fatigue Failure Analysis978-3-030-91847-7Series ISSN 2522-560X Series E-ISSN 2522-5618 作者: 出價 時間: 2025-3-27 20:29 作者: 神圣在玷污 時間: 2025-3-27 23:03
Predicting the Fatigue Life of Hydraulic Unit Under Variable Operating Conditionsake reliable individual lifetime predictions for various scenarios under real operation at HPP correctly and quickly. It helps to capture the most dangerous modes and realize smart lifetime management.作者: 事情 時間: 2025-3-28 03:25 作者: Glaci冰 時間: 2025-3-28 09:21
Fatigue Life Analysis of Strain Loadings Using Effective Strain Damage Approach with the Consideratie life of highway signals predicted using this significantly effective model is close to the predicted value using strain-life models. This is mainly because the load sequence effect was not dominant from the highway signal due to the absence of high amplitude events. Finally, the load sequence effe作者: 逃避責任 時間: 2025-3-28 11:57 作者: 恭維 時間: 2025-3-28 15:46 作者: majestic 時間: 2025-3-28 20:21 作者: Exclude 時間: 2025-3-29 01:39 作者: tenuous 時間: 2025-3-29 04:08
ture directions of research are discussed. Their freshness and immediacy inevitably leads to intense discussions and an exchange of ideas in an informal and physically charming environment. The present workshop also had a higher attendance than its predecessors, with ap- proximately 65 registered pa作者: 常到 時間: 2025-3-29 10:12 作者: Wallow 時間: 2025-3-29 14:02 作者: Perineum 時間: 2025-3-29 18:46
Nenad Radovic,Grzegorz Lesiuk,Rodoljub Vujanac stationary noise and its time-reversed version can be obtained in the second order theory by a linear nonadapted filtering of the standard vacuum noise uniquely defined by the canonical creation and annihilation operators on the spectrum of the input-output pair.作者: 截斷 時間: 2025-3-29 23:39 作者: 譏諷 時間: 2025-3-30 03:30
B. Szymczyk,G. Lesiuk,A. Zi?ty,J. Warychastricting the matter sector essentially to a set of free fields. By contrast, the matter sector of the models considered here is governed by highly non-linear interactions; its underlying group theoretical structure is a crucial ingredient in our analysis.作者: 水槽 時間: 2025-3-30 04:13
supersymmetric Yang Mills theory and resulting equivalences between field theories with different gauge group were discussed in detail. There are several roads to quantum space time and a unification of quantum theory and gravity. There is increasing evidence that canonical gravity might be a consi作者: limber 時間: 2025-3-30 10:07
Evgeniia Georgievskaiased so too there have emerged a number of natural and basic quantities which we term fundamental physical constants. Although in many cases they first occurred in a specific physical theory or in investigating a particular phenomenon, their involvement has been found to be more universal. They there作者: Constituent 時間: 2025-3-30 16:20
P. J. Huffman,J. A. F. O. Correia,A. Mour?o,T. Bittencourt,R. Cal?adarole in proton decay of supersymmetric extensions. We review the known mechanisms for avoiding this problem and present a new one which seems to lead to the (family) triplication of the gauge group. Finally, this being a summer school, we present a list of homework problems.作者: frenzy 時間: 2025-3-30 18:55
Yonghua Li,Chi Zhang,Hao Yin,Yang Cao,Xiaoning Baienters of main sequence stars where temperatures reach 10. K, neutron stars where densities reach 10.–10. g cm., our galaxy whose magnetic field can impart 10. GeV to a Dirac magnetic charge, etc.) as non-traditional laboratories for studying physics at very high energies and very short distances.作者: epicondylitis 時間: 2025-3-30 21:13 作者: defibrillator 時間: 2025-3-31 01:23
V. M. G. Gomes,J. Correia,R. Cal?ada,R. S. Barbosa,A. M. P. de Jesus of relaxation times, such as the momentum relaxation time and the energy relaxation time. In turn, these averaged quantities are the macroscopic effects of the microscopic fluctuations introduced by the scattering processes themselves. As a consequence, it is possible to relate them directly to the作者: 無意 時間: 2025-3-31 06:26
e stems from the objectives of an organization as regards overall research strategy. We have thus dealt with quantitative management techniques that have seen practical application in R&D laboratories, and have described a number of actual applications to illustrate the method of use in practice. Fo作者: 禁令 時間: 2025-3-31 09:53 作者: 積云 時間: 2025-3-31 16:47
