作者: 矛盾 時間: 2025-3-21 22:16 作者: 中國紀念碑 時間: 2025-3-22 00:32
Simeon M. Metev,Vadim P. Veikof the peripheral nerve sonography may meanwhile really be regarded as the number one imaging modality. The spectrum of peripheral nerve disease entities accessible to sonography has since the first edition of this book also broadened, but still there are white spots on the map, which warrant further作者: Duodenitis 時間: 2025-3-22 08:00 作者: 取消 時間: 2025-3-22 08:44 作者: BILIO 時間: 2025-3-22 13:12
Simeon M. Metev,Vadim P. Veikoba surface states is reduced by decreasing the film thickness, which indicates the considerable interaction of Rashba spin-split states between the surface and Bi/Si interface..978-4-431-56372-3978-4-431-55028-0Series ISSN 2190-5053 Series E-ISSN 2190-5061 作者: 逗留 時間: 2025-3-22 17:42 作者: 不安 時間: 2025-3-22 23:20 作者: alliance 時間: 2025-3-23 03:45 作者: ARY 時間: 2025-3-23 08:12
Simeon M. Metev,Vadim P. Veikooworkers started high-resolution spectroscopic stud- ies of transient molecules at a new research institute, the Institute for Molecu- lar Science in Okazaki in978-3-642-82479-1978-3-642-82477-7Series ISSN 0172-6218 Series E-ISSN 2364-9003 作者: CHIP 時間: 2025-3-23 13:42
Introduction, domain of micrometer sizes. This specific area of laser technology has found its most effective application in precisition microprocessing of small passive and active elements and components of microelectronics, optics, optoelectronics and micromechanics. In many cases its advantage results from th作者: COUCH 時間: 2025-3-23 17:39 作者: Landlocked 時間: 2025-3-23 21:04 作者: 詞匯 時間: 2025-3-23 22:45
Local Laser-Induced Heat Treatment,allowing local heating of very tiny parts. Secondly, heating rates of up to 10. K/s can be achieved for periods from a few nanoseconds to hundreds of milliseconds. This allows the precise control of thermally-induced structural modifications of material only in the zone under treatment, without affe作者: ELATE 時間: 2025-3-24 06:14 作者: Jacket 時間: 2025-3-24 07:52 作者: 性行為放縱者 時間: 2025-3-24 12:30
Simeon M. Metev,Vadim P. Veikof patients admitted to Level I trauma centers. If plexus and root injuries are included the incidence rises to about 5 °/o (. et al. 1998; . 2000). Besides the medical impact of these lesions, they constitute a major social problem, as recovery is often incomplete (especially in cases of delayed tre作者: Infantry 時間: 2025-3-24 18:31
Simeon M. Metev,Vadim P. Veikots of sonographic diagnosis and interventional therapy of th.Since the first edition of this book, sonography of the peripheral nervous system has evolved further. Not only has knowledge of the sonographic features of common neurological disorders deepened, but constant research has led to the appli作者: 解脫 時間: 2025-3-24 19:51 作者: Override 時間: 2025-3-24 23:33 作者: 連接 時間: 2025-3-25 05:25 作者: Diverticulitis 時間: 2025-3-25 10:13
Simeon M. Metev,Vadim P. Veikowide.Shows the sample preparation method for high-quality ul.In this thesis, the author has developed a high-resolution spin-resolved photoemission spectrometer that achieves the world-best energy resolution of 8 meV. The author has designed a new, highly efficient mini Mott detector that has a larg作者: Obscure 時間: 2025-3-25 13:13
Simeon M. Metev,Vadim P. Veikowide.Shows the sample preparation method for high-quality ul.In this thesis, the author has developed a high-resolution spin-resolved photoemission spectrometer that achieves the world-best energy resolution of 8 meV. The author has designed a new, highly efficient mini Mott detector that has a larg作者: 十字架 時間: 2025-3-25 18:58 作者: Clumsy 時間: 2025-3-25 20:24
er band pass of energy, and various recording units to detect the x-rays. In this chapter we deal with the experimental arrangement as a whole. There are general aspects to consider in setting-up an x-ray experiment: The sample is illuminated by an incident beam striking the sample surface under a d作者: Postulate 時間: 2025-3-26 00:55 作者: 搖曳的微光 時間: 2025-3-26 08:21
Laser Micromachining of Thin Films,atment is that laser radiation be concentrated into a zone of strictly determined shape and boundaries. This can be satisfied by two principal conditions: the use of pulsed-laser radiation and of a projection-optical set-up for the formation of the zone of interaction.作者: 過份 時間: 2025-3-26 12:00 作者: 憤慨點吧 時間: 2025-3-26 14:46
0933-033X e monograph describes fundamental aspects and practical details of the technological processes as well as the optimum conditions for their realization.978-3-642-97327-7Series ISSN 0933-033X Series E-ISSN 2196-2812 作者: BARGE 時間: 2025-3-26 17:38
Laser Microshaping,ities and often require more accurate beam focusing than is the case for laser welding and heat treating. The technological processing of materials connected with alteration of their dimensions and shapes is usually referred to as material shaping.作者: 改正 時間: 2025-3-26 23:19 作者: 種族被根除 時間: 2025-3-27 01:49
Springer Series in Materials Sciencehttp://image.papertrans.cn/l/image/581631.jpg作者: ANTE 時間: 2025-3-27 06:51 作者: coalition 時間: 2025-3-27 10:01
Laser-Based Equipment for Microtechnology, It initiates a concrete technological process in areas of precisely controllable shape and size. The laser is the main unit of the equipment and its characteristics determine, to a great extent, the qualitative and quantitative parameters of the technological treatment.作者: Ptosis 時間: 2025-3-27 16:15
Local Laser-Induced Heat Treatment,allowing local heating of very tiny parts. Secondly, heating rates of up to 10. K/s can be achieved for periods from a few nanoseconds to hundreds of milliseconds. This allows the precise control of thermally-induced structural modifications of material only in the zone under treatment, without affecting the unirradiated areas.作者: inspiration 時間: 2025-3-27 19:14 作者: Expostulate 時間: 2025-3-28 00:48
Springer-Verlag Berlin Heidelberg 1994作者: travail 時間: 2025-3-28 06:03
Laser-Assisted Microtechnology978-3-642-97327-7Series ISSN 0933-033X Series E-ISSN 2196-2812 作者: OCTO 時間: 2025-3-28 09:31 作者: 燕麥 時間: 2025-3-28 13:43
Maskless Laser Micropatterning,Laser patterning comprises a combination of laser-assisted methods for direct maskless structuring the surface of a solid [7.1–6]. This laser-assisted micro-technological lithographic technique has extensively been investigated, and some of the achievements have already found concrete industrial application [7.1–11].
