標題: Titlebook: Electronics via Waveform Analysis; Edwin C. Craig Textbook 1993 Springer-Verlag New York, Inc. 1993 Elektronik.Fourier series.Maximum.Thyr [打印本頁] 作者: 拖累 時間: 2025-3-21 18:29
書目名稱Electronics via Waveform Analysis影響因子(影響力)
書目名稱Electronics via Waveform Analysis影響因子(影響力)學科排名
書目名稱Electronics via Waveform Analysis網(wǎng)絡公開度
書目名稱Electronics via Waveform Analysis網(wǎng)絡公開度學科排名
書目名稱Electronics via Waveform Analysis被引頻次
書目名稱Electronics via Waveform Analysis被引頻次學科排名
書目名稱Electronics via Waveform Analysis年度引用
書目名稱Electronics via Waveform Analysis年度引用學科排名
書目名稱Electronics via Waveform Analysis讀者反饋
書目名稱Electronics via Waveform Analysis讀者反饋學科排名
作者: GLOOM 時間: 2025-3-21 20:40
Statische Funktionsapproximatoren,rpose. However, batteries eventually become discharged and then require recharging or replacing. Sometimes it is not feasible or desirable to use batteries due to the voltages required or the amount of current needed by the device. Therefore, another source of dc voltage is needed.作者: 使成波狀 時間: 2025-3-22 03:09
Power Supplies,rpose. However, batteries eventually become discharged and then require recharging or replacing. Sometimes it is not feasible or desirable to use batteries due to the voltages required or the amount of current needed by the device. Therefore, another source of dc voltage is needed.作者: 反復拉緊 時間: 2025-3-22 04:38 作者: hypnogram 時間: 2025-3-22 09:11
Intelligente Signalverarbeitungssysteme, solids such as silver, copper, and aluminum have many electrons that are either free or loosely bound to the atoms. These electrons are available for current flow so these solids are good conductors of electricity. In some other solids, such as glass and wood, the electrons are more tightly bound t作者: AVOID 時間: 2025-3-22 16:00
Statische Funktionsapproximatoren,rpose. However, batteries eventually become discharged and then require recharging or replacing. Sometimes it is not feasible or desirable to use batteries due to the voltages required or the amount of current needed by the device. Therefore, another source of dc voltage is needed.作者: AVOID 時間: 2025-3-22 18:17
Modellbasierte Adaptive Regelung,ectromagnetic energy that is radiated from a radio or television transmitter tower reaches a receiving antenna it induces a voltage across the antenna. This voltage has an amplitude measured in millionths of a volt (μV). In order to get the desired sound from a radio speaker or picture on a televisi作者: 叢林 時間: 2025-3-22 22:31
Nik Widmann,Stefan Kollarits,Florian Hiltis a majority of the current carriers are negative electrons while in .-type semiconductors the majority current carriers are positive holes. In the amplifying devices now under discussion, current flows through both .-type material and .-type material so current carriers of both polarities are invol作者: 表主動 時間: 2025-3-23 02:58
Grunds?tzliches zum Prozessmanagementxternal source. In the section on amplifiers, it was found that the removal of C. in the BJT amplifier, or C. in the FET amplifier, resulted in inverse or negative feedback at the emitter, or source, of those stages of amplification. This negative feedback reduced the amplification of the stage. Alt作者: Coma704 時間: 2025-3-23 07:55
Intelligentes Scoring und Ratingre the horizontal and vertical sweep circuits in television receivers as well as digital circuits including watches, calculators, and computers. The circuits that produce these square waves may be triggered or free running. Most of these circuits are composed of two stages and require positive feedb作者: 品牌 時間: 2025-3-23 12:00 作者: Haphazard 時間: 2025-3-23 15:03 作者: Conspiracy 時間: 2025-3-23 18:48
,Resümee und theoretische Integration,r four terminals, and they can be either unidirectional or bidirectional. The family of thyristors include the two-lead ac switch (DIAC), silicon-controlled recifier (SCR), light activated SCR (LASCR), silicon-controlled switch (SCS), and the TRIAC. In this chapter we will study two of these thyrist作者: 不公開 時間: 2025-3-24 01:07 作者: Debrief 時間: 2025-3-24 06:24 作者: HUMP 時間: 2025-3-24 08:58 作者: 死亡率 時間: 2025-3-24 12:10
Special Amplifiers,There are a number of amplifiers that have been designed for special applications. Most of these are based on the simple amplifiers that were discussed in the preceding two chapters. A few of the most useful of these will be discussed in this chapter.作者: 脫離 時間: 2025-3-24 16:44 作者: 浮雕寶石 時間: 2025-3-24 21:01 作者: Ringworm 時間: 2025-3-25 01:05 作者: Feature 時間: 2025-3-25 04:48 作者: DEFER 時間: 2025-3-25 09:42
Power Supplies,rpose. However, batteries eventually become discharged and then require recharging or replacing. Sometimes it is not feasible or desirable to use batteries due to the voltages required or the amount of current needed by the device. Therefore, another source of dc voltage is needed.作者: Gingivitis 時間: 2025-3-25 12:45
FET Amplifiers,ectromagnetic energy that is radiated from a radio or television transmitter tower reaches a receiving antenna it induces a voltage across the antenna. This voltage has an amplitude measured in millionths of a volt (μV). In order to get the desired sound from a radio speaker or picture on a televisi作者: vasculitis 時間: 2025-3-25 16:09
BJT Amplifiers,s a majority of the current carriers are negative electrons while in .-type semiconductors the majority current carriers are positive holes. In the amplifying devices now under discussion, current flows through both .-type material and .-type material so current carriers of both polarities are invol作者: Longitude 時間: 2025-3-25 23:16 作者: Confound 時間: 2025-3-26 00:17 作者: llibretto 時間: 2025-3-26 05:34 作者: rectum 時間: 2025-3-26 12:02
Radio and Television,/or electronic circuits that employ them. In this chapter a complete typical amplitude modulation (AM) radio receiver circuit will be studied in detail. This will be followed by a study of certain circuits used only in frequency modulation (FM) radio receivers. Selected circuits unique to television作者: 固執(zhí)點好 時間: 2025-3-26 16:24 作者: 債務 時間: 2025-3-26 20:14 作者: SYN 時間: 2025-3-26 21:33
Ultrahigh Frequencies,l energy. The differences between low-frequency and ultrahigh-frequency electric waves do not appear abruptly at any particular frequency. Although barely perceptible, they start in the low megahertz range and increase with frequency until they are quite prominent above 100 MHz. Some of the derivati作者: PRE 時間: 2025-3-27 02:58
Sine Wave Oscillators,e or negative feedback at the emitter, or source, of those stages of amplification. This negative feedback reduced the amplification of the stage. Although there are other ways in which negative feedback can be obtained in circuits, we are not interested in negative feedback at this time.作者: 誘騙 時間: 2025-3-27 08:19
Wave Shaping,sinusoidal and square waveforms were covered in the preceding chapters. This chapter deals with the methods used to modify the shapes of waveforms including clipping, clamping, differentiating, and integrating.作者: overhaul 時間: 2025-3-27 12:17
Radio and Television,l. This will be followed by a study of certain circuits used only in frequency modulation (FM) radio receivers. Selected circuits unique to television (TV) receivers will then be discussed. Since integrated circuits will be discussed in a later chapter, these circuits, to be studied now, are all composed of discrete components.作者: amphibian 時間: 2025-3-27 15:05
Thyristors,rolled recifier (SCR), light activated SCR (LASCR), silicon-controlled switch (SCS), and the TRIAC. In this chapter we will study two of these thyristors. A detailed study of the SCR will be followed by a brief study of the TRIAC.作者: 上釉彩 時間: 2025-3-27 21:19
Rüdiger Hoffmann,Matthias Wolffltaneously. The use of dual-beam oscilloscopes permits one to do this. Another technique, usable with or without the above, is to photograph the waveforms, making multiple exposures on the same print. This technique was used with a dual-beam oscilloscope by the author in preparing the photographs of waveforms presented in this book.作者: 大約冬季 時間: 2025-3-27 22:33
Nik Widmann,Stefan Kollarits,Florian Hiltived in the action. Thus they are called bipolar junction transistors or BJTs. There are two different kinds of bipolar junction transistors, . and .. Each of these devices is a single crystalline structure and is not composed of three separate crystals.作者: muscle-fibers 時間: 2025-3-28 04:16 作者: 卷發(fā) 時間: 2025-3-28 08:40 作者: Parameter 時間: 2025-3-28 12:58
Square Wave Circuits,o be in either the cutoff state or saturation. When a transistor is saturated the maximum current is flowing because all of the available current carriers are being used. When a silicon bipolar junction transistor is saturated, the voltage across it, from emitter to collector, is about 0.3 V.作者: Modify 時間: 2025-3-28 15:54
Integrated Circuits,2 indicates the voltage that is needed to heat the filament. The last number, e.g., 5, 6, or 7, was originally used to designate the number of electrodes or elements in the device, but this idea was not always used.作者: cuticle 時間: 2025-3-28 20:36
Introduction,ltaneously. The use of dual-beam oscilloscopes permits one to do this. Another technique, usable with or without the above, is to photograph the waveforms, making multiple exposures on the same print. This technique was used with a dual-beam oscilloscope by the author in preparing the photographs of waveforms presented in this book.作者: exclusice 時間: 2025-3-28 23:37
BJT Amplifiers,ved in the action. Thus they are called bipolar junction transistors or BJTs. There are two different kinds of bipolar junction transistors, . and .. Each of these devices is a single crystalline structure and is not composed of three separate crystals.作者: Lignans 時間: 2025-3-29 03:57 作者: wreathe 時間: 2025-3-29 10:44 作者: 書法 時間: 2025-3-29 12:06 作者: 外形 時間: 2025-3-29 16:41
https://doi.org/10.1007/978-3-662-63336-6sinusoidal and square waveforms were covered in the preceding chapters. This chapter deals with the methods used to modify the shapes of waveforms including clipping, clamping, differentiating, and integrating.作者: Ambulatory 時間: 2025-3-29 22:02 作者: 詢問 時間: 2025-3-30 03:52
,Resümee und theoretische Integration,rolled recifier (SCR), light activated SCR (LASCR), silicon-controlled switch (SCS), and the TRIAC. In this chapter we will study two of these thyristors. A detailed study of the SCR will be followed by a brief study of the TRIAC.作者: muscle-fibers 時間: 2025-3-30 07:27 作者: entail 時間: 2025-3-30 11:40
FET Amplifiers,d. For most usable transducers the output is in the form of electrical energy. Some examples of these transducers are sound detectors or microphones, television cameras, heat detectors, nuclear detectors, strain gauges, solar cells, and other photoelectric devices. The output voltage that is obtaine作者: cancellous-bone 時間: 2025-3-30 13:36
Ultrahigh Frequencies,t to look at some of the effects when the frequencies are in the order of 100 megahertz and higher. These get into the ultrahigh frequencies and the microwave range. First, let us discuss some of the properties of dc voltages and currents and then ac as the frequencies increase from the audio range
