標題: Titlebook: Diagnosis and Fault-Tolerant Control; Mogens Blanke,Michel Kinnaert,Marcel Staroswiecki Book 20031st edition Springer-Verlag Berlin Heidel [打印本頁] 作者: 寓言 時間: 2025-3-21 16:16
書目名稱Diagnosis and Fault-Tolerant Control影響因子(影響力)
書目名稱Diagnosis and Fault-Tolerant Control影響因子(影響力)學科排名
書目名稱Diagnosis and Fault-Tolerant Control網絡公開度
書目名稱Diagnosis and Fault-Tolerant Control網絡公開度學科排名
書目名稱Diagnosis and Fault-Tolerant Control被引頻次
書目名稱Diagnosis and Fault-Tolerant Control被引頻次學科排名
書目名稱Diagnosis and Fault-Tolerant Control年度引用
書目名稱Diagnosis and Fault-Tolerant Control年度引用學科排名
書目名稱Diagnosis and Fault-Tolerant Control讀者反饋
書目名稱Diagnosis and Fault-Tolerant Control讀者反饋學科排名
作者: Extricate 時間: 2025-3-21 21:58 作者: 排斥 時間: 2025-3-22 00:45
Fault-tolerant control of continuous-variable systems,es an overview of the available methods for dealing with faults in sensors, actuators and within the controlled system. The earlier results on diagnosis are employed to automatically re-design the control law. Small faults can be tackled by fault accommodation, where the controller parameters are ad作者: 新字 時間: 2025-3-22 07:35
Diagnosis and reconfigurable control of discrete-event systems,ution to the state observation problem developed in Section 8.3, the fault diagnostic problem will be solved in Section 8.4 by “observing” the unknown state of the fault model. Section 8.5 shows how a supervisor can be reconfigured after a fault has been detected.作者: condemn 時間: 2025-3-22 09:28 作者: 相信 時間: 2025-3-22 16:56 作者: 相信 時間: 2025-3-22 17:58
Book 20031st editionthe system. Erroneous sensor readings are the reason for operating points that are far from the optimal ones. Wear reduces the efficiency and quality of a production line. In most fault situations, the system operation has to be stopped to avoid damage to machinery and humans. As a consequence, the 作者: hieroglyphic 時間: 2025-3-22 23:50
Analysis based on components and architecture,s are discussed and their aggregation into generic components at a higher level is illustrated. Formal methods for describing generic components are introduced. Algebraic and graph-theoretic methods are employed to analyse the propagation of faults through the faulty system.作者: AGOG 時間: 2025-3-23 02:09 作者: 潰爛 時間: 2025-3-23 08:43
Fault diagnosis of continuous-variable systems,lution of these problems leads to a diagnostic system which is separated in two parts: a residual generation module and a residual evaluation module. Particular attention is paid to the link between these two parts when using stochastic models.作者: 無脊椎 時間: 2025-3-23 09:50
Diagnosis and reconfiguration of quantised systems,diagnostic and control problems can be solved. First a stochastic automaton is set up so as to represent the discrete-event behaviour of the quantised system completely. Second the given analysis and design problems are solved for the automaton by means of the methods explained in Chapter 8.作者: 噴油井 時間: 2025-3-23 13:58 作者: Boycott 時間: 2025-3-23 20:03 作者: Arroyo 時間: 2025-3-24 02:01
ication examples.Brings together the different principles foTechnological systems are vulnerable to faults. Actuator faults reduce the performance of control systems and may even cause a complete break-down of the system. Erroneous sensor readings are the reason for operating points that are far fro作者: 民間傳說 時間: 2025-3-24 04:58
Entscheidungen als Prozesse gelebter Praxislution of these problems leads to a diagnostic system which is separated in two parts: a residual generation module and a residual evaluation module. Particular attention is paid to the link between these two parts when using stochastic models.作者: 磨坊 時間: 2025-3-24 09:54 作者: hypertension 時間: 2025-3-24 13:16
Entscheidungen als Prozesse gelebter Praxisution to the state observation problem developed in Section 8.3, the fault diagnostic problem will be solved in Section 8.4 by “observing” the unknown state of the fault model. Section 8.5 shows how a supervisor can be reconfigured after a fault has been detected.作者: 燒烤 時間: 2025-3-24 17:23 作者: 侵略者 時間: 2025-3-24 19:07 作者: 尖叫 時間: 2025-3-24 23:54 作者: 規章 時間: 2025-3-25 05:39
Mogens Blanke,Michel Kinnaert,Marcel StaroswieckiIntroduces the main ideas of fault diagnosis and fault-tolerant control.Gives a thorough survey of new methods and demonstrates them by application examples.Brings together the different principles fo作者: Bridle 時間: 2025-3-25 07:53
http://image.papertrans.cn/d/image/270554.jpg作者: insecticide 時間: 2025-3-25 14:27 作者: 浮雕 時間: 2025-3-25 16:11 作者: 迫擊炮 時間: 2025-3-25 23:59
Hermes Andreas Kick,Jochen TaupitzDynamical systems can be modelled from different viewpoints. This chapter summarises the main notions. Each of the succeeding chapters uses one of these models for fault diagnosis and fault-tolerant control.作者: 合法 時間: 2025-3-26 02:04
Entscheidungen als Prozesse gelebter PraxisThis chapter uses the structure graph to describe the direct interactions among the signals. This graph is used to analyse the redundancies which can be exploited for fault diagnosis and control reconfiguration.作者: 拱形大橋 時間: 2025-3-26 06:48
Introduction to diagnosis and fault-tolerant control,This chapter introduces the aims, notions, concepts and ideas of fault diagnosis and fault tolerant control and outlines the contents of the book.作者: ornithology 時間: 2025-3-26 09:13
Examples,This chapter illustrates the main problems of diagnosis and faulttolerant control by means of two examples, which will also be used later in the text.作者: 直覺好 時間: 2025-3-26 15:53
Models of dynamical systems,Dynamical systems can be modelled from different viewpoints. This chapter summarises the main notions. Each of the succeeding chapters uses one of these models for fault diagnosis and fault-tolerant control.作者: 舊病復發 時間: 2025-3-26 17:54 作者: Horizon 時間: 2025-3-26 21:02
https://doi.org/10.1007/978-3-662-05344-7control; control system; discrete event system; discrete event systems; dynamical system; dynamical syste作者: Incommensurate 時間: 2025-3-27 04:59 作者: defray 時間: 2025-3-27 05:52 作者: 按等級 時間: 2025-3-27 12:11
Entscheidungen als Prozesse gelebter Praxisnistic or a stochastic continuous-variable system. The chapter considers faults that can be modelled as additive signals acting on the process. The solution of these problems leads to a diagnostic system which is separated in two parts: a residual generation module and a residual evaluation module. 作者: 太空 時間: 2025-3-27 17:16
https://doi.org/10.1007/978-3-531-91674-3es an overview of the available methods for dealing with faults in sensors, actuators and within the controlled system. The earlier results on diagnosis are employed to automatically re-design the control law. Small faults can be tackled by fault accommodation, where the controller parameters are ad作者: 兇猛 時間: 2025-3-27 18:09
Entscheidungen als Prozesse gelebter Praxisution to the state observation problem developed in Section 8.3, the fault diagnostic problem will be solved in Section 8.4 by “observing” the unknown state of the fault model. Section 8.5 shows how a supervisor can be reconfigured after a fault has been detected.作者: 單調女 時間: 2025-3-27 23:21 作者: 蜈蚣 時間: 2025-3-28 05:09 作者: 籠子 時間: 2025-3-28 06:32 作者: 手段 時間: 2025-3-28 11:27
Book 20031st edition years. This book introduces the main ideas of fault diagnosis and fault-tolerant control. It gives a thorough survey of the new methods that have been de- veloped in the recent years and demonstrates them by application examples. To the knowledge of the authors, all major aspects of fault-tolerant 作者: Germinate 時間: 2025-3-28 17:17 作者: 他去就結束 時間: 2025-3-28 20:02
Benjamin Gourbal,André Théron,Christoph Grunau,David Duval,Guillaume Mittahigh energy expenditures, water and air pollution, and improper care of animals (Imhoff, 2010). At the same time, food that is produced en masse is vulnerable to contamination, which is evidenced by a recent upsurge in recalls of meat, vegetable, and nut products contaminated with salmonella and E. 作者: Aqueous-Humor 時間: 2025-3-29 02:27 作者: temperate 時間: 2025-3-29 05:24 作者: 減震 時間: 2025-3-29 07:37
New Waves in Philosophy of Technologye historical development as a nation state. Australia covers a vast territory (7,682,000 square kilometres) but has a low population density. Most people are concentrated in several cities, largely on the eastern coast. Compared to other OECD countries the current population of 18.4 million is likel作者: Nomadic 時間: 2025-3-29 13:23 作者: Curmudgeon 時間: 2025-3-29 19:01
The Coagulative Cascade,a damaged vessel and to restore vascular integrity. By taking place on the surface of activated platelets, aim of coagulation is to generate fibrin meshes that stabilize the platelet plug and thus stop blood loss. Under normal conditions, anticoagulant mechanisms ensure careful control of coagulatio
