標題: Titlebook: Current Problems and Ways of Industry Development: Equipment and Technologies; Olga G. Shakirova,Oleg V. Bashkov,Akhmet A. Khusai Conferen [打印本頁] 作者: 空格 時間: 2025-3-21 16:58
書目名稱Current Problems and Ways of Industry Development: Equipment and Technologies影響因子(影響力)
書目名稱Current Problems and Ways of Industry Development: Equipment and Technologies影響因子(影響力)學科排名
書目名稱Current Problems and Ways of Industry Development: Equipment and Technologies網絡公開度
書目名稱Current Problems and Ways of Industry Development: Equipment and Technologies網絡公開度學科排名
書目名稱Current Problems and Ways of Industry Development: Equipment and Technologies被引頻次
書目名稱Current Problems and Ways of Industry Development: Equipment and Technologies被引頻次學科排名
書目名稱Current Problems and Ways of Industry Development: Equipment and Technologies年度引用
書目名稱Current Problems and Ways of Industry Development: Equipment and Technologies年度引用學科排名
書目名稱Current Problems and Ways of Industry Development: Equipment and Technologies讀者反饋
書目名稱Current Problems and Ways of Industry Development: Equipment and Technologies讀者反饋學科排名
作者: 著名 時間: 2025-3-21 20:42 作者: Banister 時間: 2025-3-22 01:49 作者: 典型 時間: 2025-3-22 05:54 作者: 種子 時間: 2025-3-22 11:16
Numerical Calculation of the Heat Sink Parameters of the Shell Turbine Vanes at the Modeling of thedence plotting of cooling parameters on the coating layers number for a given long-term strength of the shell material..: The research methodology is based on the application of the Fourier differential equation of thermal conductivity, boundary conditions of heat transfer, and the use of the develo作者: 出處 時間: 2025-3-22 15:57 作者: 出處 時間: 2025-3-22 19:46
Removing Weld Defect Causes in Aviation Stainless Steel Piping Elements,ct of welding conditions was studied for the ranges of welding amperage and shielding gas (argon) consumption, and electrode grind angle recommended by the operating procedure (PI 1.4.75 - 2000). The quality of the completed welds was determined and evaluated by visual and radiographic inspection. F作者: acquisition 時間: 2025-3-22 23:39 作者: 樸素 時間: 2025-3-23 04:28
Experimental Validation of Identification Crack Propagation in Plates as a Source of Acoustic Emissnals in metallic plate..: For research in this work, aluminum alloy 1163 was used as a sample. An initial crack was grown in the sample by means of cyclic bending. After that, the sample was loaded with a single bend with a fixed deformation using a cantilever loading device. Damage in the form of e作者: 敬禮 時間: 2025-3-23 08:17
Investigation of the Influence of Electrical Modes on the Morphology and Properties of Oxide CoatinThe studies were carried out on samples of 1163 alloy clad with aluminum. In the study, the following parameters of microarc oxidation were changed: the rate of slow voltage growth, the period of slow voltage growth. After applying the oxide coating, the surface morphology and hardness of the coatin作者: CHASE 時間: 2025-3-23 12:48
Development of an Intelligent Control System for an Autonomous Hybrid Solar System,f an intelligent control module for an automated autonomous power supply system.. The methodology for achieving the goal of work includes the development of a functional diagram containing the main groups of objects that make up the power supply system that supports the conversion of electromagnetic作者: Instrumental 時間: 2025-3-23 15:17 作者: 清洗 時間: 2025-3-23 19:54 作者: 下船 時間: 2025-3-24 00:16 作者: 心痛 時間: 2025-3-24 03:53
Modeling the Combustion Process of Solid Fuel Boilers,f various methods for determining heat losses are presented..Calculation of heat losses with exhaust gases based on the equations of complete combustion has a high computational complexity and therefore is practically not used in boiler control systems. Siegert’s formula for estimating the amount of作者: cylinder 時間: 2025-3-24 09:25 作者: 樹膠 時間: 2025-3-24 10:43 作者: 莊嚴 時間: 2025-3-24 15:11
Vibrations of a Rod Carrying a Small Attached Mass,deals with vibration of a rod carrying a small attached mass in a nonlinear formulation. Rod systems are widely used in construction. Masts, towers, television broadcast stations, TV towers, vertical pipes, etc. These structures often have balconies, antennas, and other elements which influence the 作者: Fierce 時間: 2025-3-24 21:29 作者: Sinus-Node 時間: 2025-3-25 01:51
Conference proceedings 2021nisms for the industry development: equipment and technologies,and scientific support for their activation.?..In the second part, organizational and managerial problems and ways of industry development: equipment and technologies are disclosed. The industry development: equipment and technologies we作者: 名義上 時間: 2025-3-25 03:44 作者: cavity 時間: 2025-3-25 10:54 作者: 性別 時間: 2025-3-25 11:57 作者: lanugo 時間: 2025-3-25 19:16 作者: indecipherable 時間: 2025-3-25 20:25 作者: Evolve 時間: 2025-3-26 01:21
The Mathematical Model of the Stamp Material Redistribution Using Uniform Bar Structures,tion of the topology volume, the number of rods approximating the inner region of the stamp, and also the geometric characteristics of the rods, namely, the height and cross section, are presented..: Using the presented patterns will significantly optimize the material costs for the manufacture of f作者: 使長胖 時間: 2025-3-26 06:12 作者: expeditious 時間: 2025-3-26 10:55 作者: Incompetent 時間: 2025-3-26 14:17 作者: 階層 時間: 2025-3-26 20:51
Investigation of the Influence of Electrical Modes on the Morphology and Properties of Oxide Coatinn the polarization of the anode electrode is proportional to the rate of this increase. The morphology of the coating surface obtained at the first stage of oxidation affects the formation of the base of the future MAO coating and may be uneven. At the second stage, accumulated potential of the elec作者: GET 時間: 2025-3-26 23:10 作者: MEAN 時間: 2025-3-27 05:11 作者: follicle 時間: 2025-3-27 08:13
High-Speed Energy-Efficient Power Sources for Electromechanical Systems, its terminal points, is greater than the power factor of controlled rectifiers with natural thyristor commutation. Control frequency pass band for circuit level 0.7 of the electric drive with a single-phase bridge-circuit rectifier with natural valve commutation is not less than 5?Hz; and for the c作者: MOAT 時間: 2025-3-27 11:51
Modeling the Combustion Process of Solid Fuel Boilers,acy higher than Siegert’s formula, takes into account the content of carbon, ash and humidity in the fuel, but at the same time has a low computational complexity..The results of calculating the value of heat losses in solid fuel boilers with periodic fuel loading based on modeling of the combustion作者: ULCER 時間: 2025-3-27 16:39 作者: 除草劑 時間: 2025-3-27 18:06 作者: 破布 時間: 2025-3-27 22:23 作者: 沒花的是打擾 時間: 2025-3-28 05:40 作者: Robust 時間: 2025-3-28 09:13 作者: Euphonious 時間: 2025-3-28 13:47 作者: 屈尊 時間: 2025-3-28 15:43
ERINNERUNGEN an Wolfgang Gentnerusing the climate chamber; the surfaces were visually inspected after the test. The samples surface quantitative chemical composition was determined. The samples surface roughness was contact measured..: surface dressing by ceramic granules RXX 15/15 using process equipment Rosler during 80 и 160?mi作者: 極肥胖 時間: 2025-3-28 20:17
ERINNERUNGEN an Wolfgang Gentnerf layers of heat-protective coating and changing the geometry of the cooling channels. Applying the results of calculating the cooling parameters will allow you to control the flow of the cooling process.作者: Fresco 時間: 2025-3-28 22:59
https://doi.org/10.1007/978-3-540-33701-0tion of the topology volume, the number of rods approximating the inner region of the stamp, and also the geometric characteristics of the rods, namely, the height and cross section, are presented..: Using the presented patterns will significantly optimize the material costs for the manufacture of f作者: evince 時間: 2025-3-29 03:41 作者: BATE 時間: 2025-3-29 07:57 作者: 搖擺 時間: 2025-3-29 12:49 作者: 要塞 時間: 2025-3-29 15:54 作者: 欺騙手段 時間: 2025-3-29 21:13 作者: 載貨清單 時間: 2025-3-30 01:38 作者: Goblet-Cells 時間: 2025-3-30 06:07
https://doi.org/10.1007/978-3-540-37192-2 its terminal points, is greater than the power factor of controlled rectifiers with natural thyristor commutation. Control frequency pass band for circuit level 0.7 of the electric drive with a single-phase bridge-circuit rectifier with natural valve commutation is not less than 5?Hz; and for the c作者: 精密 時間: 2025-3-30 11:51 作者: FLINT 時間: 2025-3-30 14:59
,Ressourcen und Ereignisse überwachen,nitiation at the early stages of deformation.. The presented article allows one to determine the exact values of the strain rate field and find the required optimal value of the Almansi strain tensor (E1). It is proposed to use it to characterize the choice of the preferred deformation flow of a tes作者: 驚惶 時間: 2025-3-30 19:07 作者: consolidate 時間: 2025-3-31 00:34 作者: 摻和 時間: 2025-3-31 01:57
Daten sichern und wiederherstellen,omatic systems. Their use allows us to formalize the closed system synthesis procedure and significantly reduce the system calculation time..The setting -3-1-3 and the modified setting -3-1-3 should be used in the synthesis of servo-systems that position the motor shaft angle of rotation. In this ca作者: Femish 時間: 2025-3-31 06:02 作者: Creatinine-Test 時間: 2025-3-31 11:50
Conference proceedings 2021ies. It combines the results of advanced researches of industry development: equipment and technologies in the field of various sciences?–?both technical and humanitarian, the synthesis of which allowed forming a holistic meta-scientific concept of industry development: equipment and technologies.?.作者: 鎮壓 時間: 2025-3-31 15:27
2367-3370 elected papers as a result of the Russian national conferenc.This?book is a reflection of the modern scientific view of current and future problems and prospects of industry development: equipment and technologies. It combines the results of advanced researches of industry development: equipment and作者: 凹處 時間: 2025-3-31 19:30
Wolfgang Gentner – Nestor der Arch?ometrieishable products. It is shown that this approach is applicable to the dairy cluster of the Voronezh Oblast, the structure of which includes the logistic subsystem of interaction between the producer and the consumer of the product.作者: Ballad 時間: 2025-3-31 23:43 作者: 他姓手中拿著 時間: 2025-4-1 05:35 作者: 混合物 時間: 2025-4-1 07:42 作者: adduction 時間: 2025-4-1 13:18
Olga G. Shakirova,Oleg V. Bashkov,Akhmet A. KhusaiDiscusses perspectives and key scientific & practical problems of innovative development of the modern equipment and technologies.Includes selected papers as a result of the Russian national conferenc作者: seroma 時間: 2025-4-1 16:07 作者: Endometrium 時間: 2025-4-1 21:15
Wolfgang Gentner – Nestor der Arch?ometrieng into account this specificity of resources. Product shelf life is key in optimizing and synchronizing supply and manufacturing processes. An approach to optimization of delivery not based on VMI-technology of joint inventory management with an extended module for monitoring stocks of perishable g作者: 水汽 時間: 2025-4-2 00:02
