標題: Titlebook: Balancing of High-Speed Machinery; Mark S. Darlow Book 1989 Springer-Verlag New York Inc. 1989 Rotor.design.development.machines.turbomach [打印本頁] 作者: 板條箱 時間: 2025-3-21 19:45
書目名稱Balancing of High-Speed Machinery影響因子(影響力)
書目名稱Balancing of High-Speed Machinery影響因子(影響力)學科排名
書目名稱Balancing of High-Speed Machinery網絡公開度
書目名稱Balancing of High-Speed Machinery網絡公開度學科排名
書目名稱Balancing of High-Speed Machinery被引頻次
書目名稱Balancing of High-Speed Machinery被引頻次學科排名
書目名稱Balancing of High-Speed Machinery年度引用
書目名稱Balancing of High-Speed Machinery年度引用學科排名
書目名稱Balancing of High-Speed Machinery讀者反饋
書目名稱Balancing of High-Speed Machinery讀者反饋學科排名
作者: 溫和女孩 時間: 2025-3-21 21:09
Introduction,mall gyroscopes weighing only a few ounces to large rock tumblers weighing several tons. Other examples of rotating machines are household electric motors, internal combustion engines, gas turbine engines, steam turbines, electric generators, industrial compressors and power transmission systems, to name just a few.作者: Cognizance 時間: 2025-3-22 04:02
Theoretical Background,cing requirements. Control of rotor vibration is necessary to maintain reasonable noise levels and to ensure operator, and consumer safety, and machinery survival. In general, the operating expense of rotating machinery is a direct function of the success with which rotor vibrations are controlled.作者: Admonish 時間: 2025-3-22 05:49 作者: LAP 時間: 2025-3-22 08:49 作者: travail 時間: 2025-3-22 16:39
Rotor Balancing Methods and Instrumentation, its operating speed, is actually very poorly balanced and potentially destructive. Specific rigid and flexible rotor balancing methods are discussed in considerable detail in this and the following several chapters.作者: 鐵砧 時間: 2025-3-22 19:53 作者: resuscitation 時間: 2025-3-22 23:12 作者: abnegate 時間: 2025-3-23 04:48
0941-5122 tly, there is an increased need to balance high-speed rotors. The purpose of this book is to provide the engineering student or practicing engineer with a single, complete reference on high-speed rotor balancing. To this end, a detailed analytical background and practical application procedures are 作者: guzzle 時間: 2025-3-23 08:23
https://doi.org/10.1007/978-3-662-34550-4 actual hardware application. Consequently, modal balancing, influence coefficient balancing and the Unified Balancing Approach were compared experimentally in a test program involving a supercritical power transmission shaft test rig.作者: AMEND 時間: 2025-3-23 11:16
Experimental Comparisons of the Various Methods, actual hardware application. Consequently, modal balancing, influence coefficient balancing and the Unified Balancing Approach were compared experimentally in a test program involving a supercritical power transmission shaft test rig.作者: 護身符 時間: 2025-3-23 17:46
,Geschichte der Eisen- und Stahlgie?erei,mall gyroscopes weighing only a few ounces to large rock tumblers weighing several tons. Other examples of rotating machines are household electric motors, internal combustion engines, gas turbine engines, steam turbines, electric generators, industrial compressors and power transmission systems, to name just a few.作者: mendacity 時間: 2025-3-23 20:37 作者: Obsessed 時間: 2025-3-24 00:07 作者: 音樂戲劇 時間: 2025-3-24 05:31 作者: Infant 時間: 2025-3-24 08:47 作者: 昆蟲 時間: 2025-3-24 11:48 作者: 生氣地 時間: 2025-3-24 15:56
Handbuch der Eisen-und Stahligiesserei,r or not rotor flexibility is taken into account. That is, flexible rotor balancing procedures take into account rotor flexibility, while rigid rotor balancing procedures do not. Many flexible rotor balancing methods are suitable for balancing rigid rotors. However, rigid rotor balancing methods are作者: reject 時間: 2025-3-24 20:00
https://doi.org/10.1007/978-3-642-50686-4eloped, but are largely intuitive in nature. They seek to balance the rotor, one mode at a time, with a set of masses specifically selected not to disturb previously balanced, lower modes. This chapter includes the analytical background and typical procedures for modal balancing.作者: temperate 時間: 2025-3-24 23:13 作者: 粗糙濫制 時間: 2025-3-25 04:47
https://doi.org/10.1007/978-3-662-34550-4iminating the disadvantages of both methods. That is, the Unified Balancing Approach uses a modal method of applying correction masses in modal sets using data derived in an empirical manner and requiring a minimum of prior knowledge of the dynamics of the rotor. Essentially, the technique involves 作者: Genome 時間: 2025-3-25 08:57 作者: 注意 時間: 2025-3-25 13:27 作者: 征兵 時間: 2025-3-25 17:01
Balancing of High-Speed Machinery978-1-4612-3656-6Series ISSN 0941-5122 Series E-ISSN 2192-063X 作者: frugal 時間: 2025-3-25 21:49 作者: placebo-effect 時間: 2025-3-26 01:11
Modal Balancing,eloped, but are largely intuitive in nature. They seek to balance the rotor, one mode at a time, with a set of masses specifically selected not to disturb previously balanced, lower modes. This chapter includes the analytical background and typical procedures for modal balancing.作者: 緯線 時間: 2025-3-26 05:49
https://doi.org/10.1007/978-1-4612-3656-6Rotor; design; development; machines; turbomachinery; vibration作者: Minatory 時間: 2025-3-26 10:30
978-1-4612-8194-8Springer-Verlag New York Inc. 1989作者: GIST 時間: 2025-3-26 15:11 作者: Tonometry 時間: 2025-3-26 17:37
https://doi.org/10.1007/978-3-642-50686-4iminate, or minimize, the synchronous rotor response due to unbalance. The analytical development and implementation procedures for influence balancing are presented in this chapter. A method for identifying and eliminating non-independent balancing planes is also presented.作者: 沖擊力 時間: 2025-3-26 22:43
https://doi.org/10.1007/978-3-662-34550-4e modes above and below the mode being excited. In general, the number of planes required for the modal trial mass set is one more than the number of modes which must not be affected. In addition, the Unified Balancing Approach is not restricted to planar modes. In this chapter, the theoretical deve作者: Epithelium 時間: 2025-3-27 03:37
Magnetismus und Elektromagnetismus,e unbalance at .. This is true even in the presence of damping. This chapter begins with a theoretical discussion of the principle of reciprocity and its application to flexible rotor balancing. The particular means by which reciprocity can be applied to improve the influence coefficient and Unified作者: osteocytes 時間: 2025-3-27 06:28
Influence Coefficient Balancing,iminate, or minimize, the synchronous rotor response due to unbalance. The analytical development and implementation procedures for influence balancing are presented in this chapter. A method for identifying and eliminating non-independent balancing planes is also presented.作者: 名字的誤用 時間: 2025-3-27 12:39
The Unified Balancing Approach,e modes above and below the mode being excited. In general, the number of planes required for the modal trial mass set is one more than the number of modes which must not be affected. In addition, the Unified Balancing Approach is not restricted to planar modes. In this chapter, the theoretical deve作者: antedate 時間: 2025-3-27 16:05 作者: CUB 時間: 2025-3-27 20:50 作者: 四海為家的人 時間: 2025-3-27 22:58 作者: agglomerate 時間: 2025-3-28 03:27
Review of Literature on Rotor Balancing,to the rotor balancing literature did not appear until about 1930. Prior to the 1950s, the balancing literature was concerned with the balancing of rigid rotors and, in a few cases, very simple flexible ones. There is no documentation during this period of any systematic balancing procedure using mo作者: Solace 時間: 2025-3-28 08:26
Rotor Balancing Methods and Instrumentation,r or not rotor flexibility is taken into account. That is, flexible rotor balancing procedures take into account rotor flexibility, while rigid rotor balancing procedures do not. Many flexible rotor balancing methods are suitable for balancing rigid rotors. However, rigid rotor balancing methods are作者: Metamorphosis 時間: 2025-3-28 14:29
Modal Balancing,eloped, but are largely intuitive in nature. They seek to balance the rotor, one mode at a time, with a set of masses specifically selected not to disturb previously balanced, lower modes. This chapter includes the analytical background and typical procedures for modal balancing.作者: 怕失去錢 時間: 2025-3-28 16:33 作者: 發牢騷 時間: 2025-3-28 22:26
The Unified Balancing Approach,iminating the disadvantages of both methods. That is, the Unified Balancing Approach uses a modal method of applying correction masses in modal sets using data derived in an empirical manner and requiring a minimum of prior knowledge of the dynamics of the rotor. Essentially, the technique involves 作者: 狂亂 時間: 2025-3-29 02:41
Experimental Comparisons of the Various Methods,have, in addition to theoretical appeal, demonstrated practical appeal. That is, it is necessary to demonstrate both effectiveness and usability in an actual hardware application. Consequently, modal balancing, influence coefficient balancing and the Unified Balancing Approach were compared experime作者: 偽造 時間: 2025-3-29 05:10
Application of the Principle of Reciprocity to Flexible Rotor Balancing,importance in the balancing of machines which require a substantial stabilization time during start-up. Using an adaptation of the principle of reciprocity, it is possible to significantly reduce the required number of trial mass runs for certain rotors when using either influence coefficient balanc
