派博傳思國際中心

標題: Titlebook: A New Theory of Additive Manufacturing; Solvable and Unsolva Sanjay Kumar Book 2025 The Editor(s) (if applicable) and The Author(s), under [打印本頁]

作者: Body-Mass-Index 時間: 2025-3-21 18:48
書目名稱A New Theory of Additive Manufacturing影響因子(影響力)

書目名稱A New Theory of Additive Manufacturing影響因子(影響力)學科排名

書目名稱A New Theory of Additive Manufacturing網絡公開度

書目名稱A New Theory of Additive Manufacturing網絡公開度學科排名

書目名稱A New Theory of Additive Manufacturing被引頻次

書目名稱A New Theory of Additive Manufacturing被引頻次學科排名

書目名稱A New Theory of Additive Manufacturing年度引用

書目名稱A New Theory of Additive Manufacturing年度引用學科排名

書目名稱A New Theory of Additive Manufacturing讀者反饋

書目名稱A New Theory of Additive Manufacturing讀者反饋學科排名

作者: enchant 時間: 2025-3-21 20:26

作者: 遺棄 時間: 2025-3-22 00:52

作者: 小說 時間: 2025-3-22 06:28

作者: HALL 時間: 2025-3-22 09:22

作者: 組成 時間: 2025-3-22 12:57

作者: 觀察 時間: 2025-3-22 19:32
https://doi.org/10.1007/978-3-658-03561-7ping methods to convert the arrangement into parts. It is given how manufacturing problems arise due to the layer arrangement. The problems are basis to divide AM into two categories: one category, where there will be problems because the problems are not solvable, and another category, where there

作者: Exclude 時間: 2025-3-23 00:30

作者: STERN 時間: 2025-3-23 01:31

作者: acrophobia 時間: 2025-3-23 08:18

作者: 最初 時間: 2025-3-23 13:44

作者: 懲罰 時間: 2025-3-23 16:57

作者: oracle 時間: 2025-3-23 19:34
Introduction,The chapter introduces various concepts of additive manufacturing (AM) briefly. To explain complexity, it introduces the difference between simple and complex products. To explain the differences, advantages of AM are given. To explain the advantages, limitations of machine tools are given briefly.

作者: 黑豹 時間: 2025-3-24 01:34
2690-0300 nsolvable .Written in the form of questions and concise answ.This is the first book on Additive Manufacturing that provides an original theory for the entire subject.? It is the culmination of a search for the root cause of manufacturing problems that occur in practice.? The author finds a reason wh

作者: 懲罰 時間: 2025-3-24 06:18

作者: 惹人反感 時間: 2025-3-24 07:32
Book 2025uring products and divides fabrication problems in additive manufacturing into two types: solvable and unsolvable. This allows readers to anticipate/avoid difficulty in manufacturing, saving materials, time, and resources.? ?.

作者: 權宜之計 時間: 2025-3-24 14:06